Special Tools
Order special tools from your Toro Distributor.
Centrifugal Clutch Puller
The centrifugal clutch puller should be used to remove
the clutch from the engine crankshaft.
2
1
Toro Part Number: 114- -7730
To use the clutch puller (Fig. 1):
1. To protect the engine crankshaft, place thick washer
on end of crankshaft and lightly grease the end of the ro-
tator pin.
2. Thread puller stator base (item 2) into bore of centrif-
Figure 1
ugal clutch.
1. Rotator pin
2. Stator base
3. Tighten puller rotator pin (item 1) until it is snug with
washer on engine crankshaft.
4. Support clutch to prevent it from falling. Using a ham-
mer, strike end of puller rotator pin to loosen clutch from
tapered engine crankshaft.
Engine
Page 3 - - 4
ProCore Processor