Toro Greensmaster 3200 Service Manual page 42

F. Install alternator guard (29) to the radiator sup-
port (8) and frame bracket.
G. Make sure hoses are clear of rotating parts.
Make sure cable ties and clamps securing hoses to
the frame and supports are installed.
13. Install fuel filter (39) to the front engine mount (13).
Connect fuel hose (17) to the carburetor on the engine
(1) (Fig. 18).
14. Disconnect fuel hose (17) from the carburetor on the
engine (1) (Fig. 18).
15. Install muffler as follows (Fig. 24):
A. Secure muffler to the pump plate with two cap
screws.
B. Install muffler shield to the muffler and pump
plate with four cap screws.
C. Secure exhaust plate to the engine exhaust
manifold with four cap screws and flat washers.
16. Install air cleaner as follows (Fig. 23):
A. Secure air cleaner and bracket to the pump
plate.
B. Connect hose leading to the radiator to the
cleaner.
C. Route and connect hose, leading from the clean-
er to the engine valve cover, to the valve cover and
cleaner.
Vanguard 3/LC Gasoline Engine
17. Install fuel tank and hydraulic reservoir as follows:
A. Position mounting plate and tanks onto the
frame.
B. If the oil cooler is not installed, Connect hydrau-
lic hose to the hydraulic oil filter (Fig. 22).
C. Connect hydraulic hose to the welded fitting on
the tube leading into rear bulkhead (Fig. 21).
D. Remove plug from the pump inlet hose and gear
pump. Install pump inlet hose to the gear pump with
hose clamp (Fig 19).
E. Connect expansion tank hose (25) to the radia-
tor elbow (27) (Fig. 16).
F. Make sure hoses are secured to the frame and
supports with cable ties and hose clamps.
G. Secure tank mounting plate (13) to the support
bracket (28) and frame with three cap screws (6)
and two flat washers (14) (Fig. 17).
18. Connect hydraulic oil cooler if installed (Fig. 20).
A. Connect tube and O–ring to hydraulic fitting on
the hydraulic reservoir.
B. Connect tube and O–ring to hydraulic fitting on
the oil filter.
19. Install screen (10) into the radiator support (8) (Fig.
16).
20. Install console shroud to the control panel.
21. Make sure fuel shutoff valve is open (see Fuel Shut-
off Valves). Fill fuel tank with fuel (see Fill Fuel Tank).
Check tank and hoses for leaks.
22. Fill cooling system with coolant (see Check Cooling
System). Check radiator and hoses for leaks.
23. Fill hydraulic reservoir with hydraulic oil (see Check
Hydraulic System Fluid in Chapter 5 – Hydraulic Sys-
tem). Check reservoir and hoses for leaks.
Page 3 – 24
Greensmaster 3200