Toro Greensmaster 3200 Service Manual page 71

12. Install muffler as follows (Fig. 34):
A. Secure muffler to the pump plate with two cap
screws.
B. Install muffler shield to the muffler and pump
plate with four cap screws.
C. Secure exhaust plate to the engine exhaust
manifold with four cap screws and flat washers.
13. Install air cleaner as follows (Fig. 33):
A. Secure air cleaner and bracket to the pump
plate.
B. Connect hose leading to the radiator to the
cleaner.
C. Route and connect hose, leading from the clean-
er to the engine valve cover, to the valve cover and
cleaner.
14. Install fuel tank and hydraulic reservoir as follows:
A. Position mounting plate and tanks onto the
frame.
B. If the oil cooler is not installed, Connect hydrau-
lic hose to the hydraulic oil filter (Fig. 32).
C. Connect hydraulic hose to the welded fitting on
the tube leading into rear bulkhead (Fig. 31).
D. Remove plug from the pump inlet hose and gear
pump. Install pump inlet hose to the gear pump with
hose clamp (Fig 29).
E. Connect expansion tank hose (25) to the radia-
tor elbow (26) (Fig. 26).
Greensmaster 3200–D
F. Connect fuel hose (36) and expansion tank hose
(50) to the support bracket (14). Connect fuel hose
(35) to the number three fuel injector (Fig. 28).
G. Make sure hoses are secured to the frame and
supports with cable ties and hose clamps.
H. Connect fuel hose (36) to fuel filter (49) (Fig. 28).
I. Secure tank mounting plate (13) to the support
bracket (28) and frame with three cap screws (6)
and two flat washers (14) (Fig. 27).
15. Connect hydraulic oil cooler if installed (Fig. 30).
A. Connect tube and O–ring to hydraulic fitting on
the hydraulic reservoir.
B. Connect tube and O–ring to hydraulic fitting on
the oil filter.
16. Install screen (10) into the radiator support (8) (Fig.
26).
17. Install console shroud to the control panel.
18. Make sure both fuel shutoff valves are open (see
Fuel Shutoff Valves). Fill fuel tank with fuel (see Fill Fuel
Tank). Check tank and hoses for leaks.
19. Fill cooling system with coolant (see Check Cooling
System). Check radiator and hoses for leaks.
20. Fill hydraulic reservoir with hydraulic oil (see Check
Hydraulic System Fluid in Chapter 5 – Hydraulic Sys-
tem). Check reservoir and hoses for leaks.
21. Bleed fuel system (see Bleeding Fuel System).
22. Adjust throttle control lever and cable (see Throttle
Adjustment).
Page 4 – 29 Perkins Diesel Engine