Toro Greensmaster 3200 Service Manual page 93

5. Completely open load valve in the hydraulic tester
(when using tester with pressure and flow capabilities)
to minimize the possibility of damaging components.
6. Install fittings finger tight and far enough to insure
that they are not cross–threaded before tightening them
with a wrench.
7. Position tester hoses so that rotating machine
parts will not contact them and result in damage to the
hoses or tester.
Greensmaster 3200/3200–D
8. Check oil level in the reservoir. Make sure reservoir
if full.
9. Check the traction pedal linkage for improper ad-
justment, binding,or broken parts.
10. All hydraulic tests should be made with the hydraulic
oil at normal operating temperature.
Rev. C
Page 5 – 21 Hydraulic System