Leveling The Front Roller To The Reel - Toro Greensmaster 3250-D Operator's Manual

Position 2:
Standard position; use for most conditions.
Height-of-cut range: 2.4mm–18.3mm
Frame
Position 2
The top frame hole and top bracket hole
Note:
will yield position 2 (standard position).
Position 3:
More aggressive; use on firm turf or higher height of
cuts.
Height-of-cut range: 2.4mm–15.7mm
Frame
Position 3
Position 4:
Most aggressive; use only on very firm greens or at
the higher heights of cut.
Height-of-cut range: 2.4mm–12.7mm
Frame
Position 4
A more aggressive setting will increase
Note:
grass removal and provide a cleaner cut, but may
cause increased scalping and marking.
A more aggressive setting will be required
Note:
Bracket
Down
Bracket
Down
Bracket
Down
to compensate for reel wear.
Leveling the Front Roller to the
Reel
1. Position the cutting unit on a flat, level surface.
2. Position a 6 mm or thicker plate under the reel
blades and against the front face of the bedknife.
Be sure the plate covers the full length of
Note:
the reel blades and three blades contact the plate.
3. Loosen the locknuts retaining the right-front roller
bracket.
1
1. Right front roller bracket
2. Upper right roller mounting bolt
4. While holding the reel securely on the plate and
maintaining pressure on the front roller, rotate the
upper right roller mounting bolt (Fig. 4). This
mounting bolt has an offset, which when rotated,
acts as an eccentric (cam) to raise or lower the
roller. On the bolt head there is an internal
diameter dot that denotes the offset of the bolt.
The dot indicates the direction in which the right
end of the roller moves when the bolt is turned.
Note: If additional adjustment is required, replace
one screw on the left-hand bracket with another
bolt, part no. 93-2573. Make sure that both front
roller brackets are in the same hole.
5. To verify whether the roller is level, try inserting a
piece of paper under each end of the roller.
6. When the roller is level, tighten the nuts securely.
4
2
Figure 4