How Can I Change The System Site Name - Huawei ECC500 User Manual

ECC500
User Manual
----End

7.13 How Can I Change the System Site Name?

Prerequisites


Context
Site network fault alarms are sent to the specified mobile phone numbers of maintenance
engineers through SMS. After the system site name is changed, the new site name will be
displayed in the short message content (for example, XXX site network fault) so that
maintenance engineers will know the site where the fault has occurred.
Procedure
Step 1 Log in to the ECC500 WebUI.
Step 2 Choose System Settings > Site Settings.
Step 3 Modify System Site Name.
Step 4 Click Submit, as shown in
Figure 7-14 Changing the system site name
Issue 04 (2019-12-20)
 If DO Settings is set to Disable, the DO port does not take effect.
 If DO Settings is set to Association, the AI/DI alarm is associated with the DO port. If the AI/DI
port reports an alarm, the DO port reacts accordingly.
 If DO Settings is set to Manual, you can select DO Operation to change the DO signal status to
control whether the device is running.
You have obtained the ECC500 IP address as well as the user name and password for
WebUI login.
You have prepared a PC which is in the same IP address segment as the ECC500 and
connected the PC to the ECC500 over a switch.
Copyright © Huawei Technologies Co., Ltd.
Figure 7-14.
7 FAQ
79