Table 340 Dhcp Command; Table 341 Gi-Address Command; Ies Interface Dhcp Commands - Nokia 7302 Manual

Internet Enhanced Service
6.10.5
6.10.5.1
Table 340
6.10.5.2
Table 341
380

IES Interface DHCP Commands

dhcp
dhcp command
Item Description
Syntax dhcp
Context configure>service>ies>interface
Description This command enables the context to configure DHCP parameters.
gi-address
gi-address command
Item Description
Syntax gi-address ip-address [src-ip-addr]
no gi-address
Context configure>service>ies>interface>dhcp
Description This command configures the gateway interface address for the DHCP relay. The GI address
is needed, when the router functions as a DHCP relay, to distinguish between different
interfaces.
By default, the GI address used in the relayed DHCP packet is the primary IP address of the
interface on which the DHCP boot requests are relayed. Any primary or any secondary
address of an interface of the concerned router instance can also be specified.
Default No gi-address
Parameters ip-address — Specifies the host IP address to be used for DHCP relay packets.
src-ip-address — Specifies that this GI address is to be the source IP address for DHCP relay
packets.
3HH-11985-AAAA-TQZZA
FD 100/320Gbps NT and FX NT IHub Services Guide
Issue: 13