Ingress-Label; Table 86 Ingress-Label Command; Table 87 Show Service Ingress Label Output Fields - Nokia 7302 Manual

FD 100/320Gbps NT and FX NT IHub Services Guide
4.6.6.2
Table 86
Table
Table 87
Issue: 13

ingress-label

ingress-label command
Item Description
Syntax ingress-label start-label [end-label]
Context show>service
Description This command displays services using the range of egress labels. If only the mandatory
start-label parameter is specified, only services using the specified label are displayed.
If both start-label and end-label parameters are specified, the services using the range of
labels X where start-label <= X <= end-label are displayed.
Use the show router vprn-service-id ldp bindings command to display dynamic labels.
Parameters start-label — The starting egress label value for which to display services using the label
range. If only start-label is specified, services only using start-label are displayed.
Values: 0, 2048 — 131071
end-label — The ending egress label value for which to display services using the label range.
Default: the start-label value
Values: 2049 — 131071
87 describes the command output fields.
Show Service Ingress Label Output Fields
Label Description
Svc Id The ID that identifies a service.
Sdp Id The ID that identifies an SDP.
Type Indicates whether the SDP binding is a spoke or a mesh.
I. Lbl The VC label used by the far-end device to send packets to this device in this service by
the SDP.
E. Lbl The VC label used by this device to send packets to the far-end device in this service by
the SDP.
Number of bindings The total number of SDP bindings that exist within the specified egress label range.
found
3HH-11985-AAAA-TQZZA
Virtual Leased Line Services
143