Table 132 Static-Mac Command; Table 133 Suppress-Standby-Signaling Command; Static-Mac - Nokia 7302 Manual

Virtual Private LAN Service
(2 of 2)
5.16.2.9
Table 132
5.16.2.10
Table 133
256
Item Description
Parameters revert-time — [0..600 seconds]
infinite — makes endpoint non-revertive

static-mac

static-mac command
Item Description
Syntax static-mac ieee-address [create]
no static-mac
Context configure>service>vpls>endpoint
Description This command assigns a static-mac to the endpoint. In FDB, the static-mac is then associated
with the active spoke SDP.
Default None
Parameters ieee-address — 6-byte mac-address (xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx). Cannot be all
zeros.
suppress-standby-signaling
suppress-standby-signaling command
Item Description
Syntax [no] suppress-standby-signaling
Context configure>service>vpls>endpoint
Description When this command is enabled, the pseudowire standby bit (value 0x00000020) will not be
sent to TLDP peer when the given spoke is selected as a standby. This allows faster
switchover as the traffic will be sent over this SDP and discarded at the blocking side of the
connection. This is particularly applicable to multicast traffic.
Default Enabled
3HH-11985-AAAA-TQZZA
FD 100/320Gbps NT and FX NT IHub Services Guide
Issue: 13