Table 233 Dot1P Command; Dot1P - Nokia 7302 Manual

FD 100/320Gbps NT and FX NT IHub Services Guide
(2 of 2)
5.16.5.15
Table 233
Issue: 13
Item Description
Context configure>service>vpls>egress>rate-limit-pbits
Description This command defines the aggregate egress rate limit for the v-VPLS service matching the
dot1p bits specified through rate-limit-pbits. It applies to traffic associated to the service which
is egressing on regular ports (network ports).
The committed information rate and the peak information rate are specified.
Optionally, the committed burst size and the peak burst size may be entered. If these values
are not specified, they assume the default value of 256 Mbytes.
More information on rate-limiting and some constraints regarding the granularity of the values
for rate and burst-size can be found in the FD 100/320Gbps NT and FX NT IHub Qos Guide.
Parameters cir-rate — The cir parameter defines the CIR rate, in kilobits, used for the service. When the
rate-limit-pbits command is executed, a valid CIR setting must be explicitly defined.
Values: 0...100000000, max
pir-rate — The pir parameter defines the administrative PIR rate, in kilobits, used for the
service. When the rate-limit-pbits command is executed, a valid PIR setting must be explicitly
defined. pir-rate acts as EIR rate as defined in RFC 4115 when tr-tcm-modified mode is
configured, which means that in tr-tcm-modified mode the actual peak rate achieved is cir-rate
+ pir-rate.
Values: 0...100000000, max
cbs-size — The cbs parameter defines the CBS size, in kilobytes, used for the service. When
the rate-limit-pbits command is executed, the cbs parameter can be optionally specified. If
not specified, the default value of 256 Mbytes is assumed.
Values: 1...262144, default
pbs-size — The pbs parameter defines the PBS size, in kilobytes, used for the service. When
the rate-limit-pbits command is executed, the pbs parameter can be optionally specified. If
not specified, the default value of 256 Mbytes is assumed.
Values: 1...262144, default

dot1p

dot1p command
Item Description
Syntax dot1p dot1p-priority1 [dot1p-priority2] .. [dot1p-priority8]
no dot1p
Context configure>service>vpls>egress>rate-limit-pbits
Description This command allows to define the set of 802.1p bits for which the rate-limiter will be applied.
The no form of this command resets all the configured 802.1p values.
When the no form of this command is given, pbit rate-limiting will be applied for all dot1p values
(default).
Parameters dot1p-priority — Priority.
Values: 0 - 7
3HH-11985-AAAA-TQZZA
Virtual Private LAN Service
309