Table 531 Passive Command; Table 532 Peer-As Command; Passive - Nokia 7302 Manual

Virtual Private Routed Network Service
7.10.9.34
Table 531
7.10.9.35
Table 532
518

passive

passive command
Item Description
Syntax [no] passive
Context configure>service>vprn>bgp>group
configure>service>vprn>bgp>group>neighbor
Description This command enables passive mode for the BGP group or neighbor.
When in passive mode, BGP will not attempt to actively connect to the configured BGP peers
but responds only when it receives a connect open request from the peer.
The no form of the command used at the group level disables passive mode where BGP
actively attempts to connect to its peers.
The no form of the command used at the neighbor level reverts to the value defined at the
group level.
Default no passive — BGP will actively try to connect to all the configured peers.
peer-as
peer-as command
Item Description
Syntax peer-as as-number
no peer-as
Context configure>service>vprn>bgp>group
configure>service>vprn>bgp>group>neighbor
Description This command configures the autonomous system number for the remote peer. The peer AS
number must be configured for each configured peer.
For EBGP peers, the peer AS number configured must be different from the autonomous
system number configured for this router under the global level since the peer will be in a
different autonomous system than this router
For IBGP peers, the peer AS number must be the same as the autonomous system number of
this router configured under the global level.
This is a required command for each configured peer. This may be configured under the group
level for all neighbors in a particular group.
Default no peer-as
Parameters as-number — The autonomous system number, expressed as a decimal integer.
Values: 1 — 65535
3HH-11985-AAAA-TQZZA
FD 100/320Gbps NT and FX NT IHub Services Guide
Issue: 13