FD 100/320Gbps NT and FX NT IHub Services Guide
(2 of 2)
6.10.5.8
Table 347
6.10.6
6.10.6.1
Table 348
(1 of 2)
Issue: 13
Item
Description
Description
This command enables dynamic host lease state management for IES IP interfaces. Lease
state information is extracted from snooped or relayed DHCP ACK messages to populate lease
state table entries for the IP interface.
If lease state population is enabled and an entry cannot be added to the table, the system will
prevent the far-end host from receiving the DHCP ACK message.
Default
lease-populate 16384
Parameters
<nbr-of-leases> — This optional parameter defines the number of lease state table entries
allowed for this IP interface. Once the maximum number of entries has been reached,
subsequent lease state entries are not allowed.
The system wide maximum number of leases allowed with all IP interfaces is 24576 including
IPv4 and IPv6 leases.
Values: 1—16384
rid-check-disable
rid-check-disable command
Item
Description
Syntax
rid-check-disable
no rid-check-disable
Context
configure>service>ies>if>dhcp
Description
This command disables the remote ID check in the interface.
Local Proxy ARP should be enabled in the respective interface.
Default
Remote ID check is enabled (no rid-check-disable)
Parameters
None
IES Interface ICMP Commands
icmp
icmp command
Item
Description
Syntax
icmp
3HH-11985-AAAA-TQZZA
Internet Enhanced Service
383