Ldp; Lsp; Table 11 Ldp Command; Table 12 Lsp Command - Nokia 7302 Manual

FD 100/320Gbps NT and FX NT IHub Services Guide
3.17.3.4
Table 11
3.17.3.5
Table 12
(1 of 2)
Issue: 13

ldp

ldp command
Item Description
Syntax [no] ldp
Context configure>service>sdp sdp-id
Description This command enables LDP-signaled LSPs on MPLS-encapsulated SDPs.
In MPLS SDP configurations either one LSP can be specified or LDP can be enabled. The
SDP ldp and lsp commands are mutually exclusive. If an LSP is specified on an MPLS SDP,
then LDP cannot be enabled on the SDP. To enable LDP on the SDP when an LSP is already
specified, the LSP must be removed from the configuration using the no lsp lsp-name
command.
Alternatively, if LDP is already enabled on an MPLS SDP, then an LSP cannot be specified on
the SDP. To specify an LSP on the SDP, the LDP must be disabled. The LSP must have
already been created in the configure>router>mpls context with a valid far-end IP address.
Default no ldp (disabled)

lsp

lsp command
Item Description
Syntax lsp lsp-name
no lsp lsp-name
Context configure>service>sdp sdp-id
3HH-11985-AAAA-TQZZA
Services Overview
83