Nokia 7302 Manual page 211

FD 100/320Gbps NT and FX NT IHub Services Guide
When creating the MEP, MDs and MAs are associated and in addition, the following
parameters are required:
•
•
•
The MEP must be administratively enabled using the no shutdown command
The following CLI command syntax can be used to create or modify a MEP/MIP on
a SAP:
configure>service>vpls# info
----------------------------------------------
----------------------------------------------
For MIP:
config>service>Vpls# info
----------------------------------------------
----------------------------------------------
Issue: 13
MEP-ID - The ID value used to identify the MEP in the MA. This ID value must be
listed in the remote-MEP-iD list in the MA configuration of the other PE router.
Correlate the MEP with the correct MD and MA. When configuring the correlation,
the index value is used instead of the name of the MD and MA. All MEPs that
belong to the same MA must have the same MA name and MD level.
Direction - The CFM message flow direction.
If the CFM message should travel from the SAP to the fabric, then over the
pseudo wires to reach the far-end SAPs where the other MEPs are configured
then the direction must be set as "up". That is, the CFM messages are sent from
the SAP up to the fabric.
If the CFM message must be sent through the port directly out to the network then
the direction must be set as "down".
Default value for a MEP/MIP is "down"
MAC address (optional) - The source MAC address of the CFM messages can be
defined in the MEP. By default, the system MAC address is used as the source
MAC address for all CFM messages. For ease of troubleshooting and
management, specific MAC addresses can be used for CFM messages.
sap nt-a:sfp:1:100 create
eth-cfm
mep 5 domain 50 association 1 direction down
no shutdown
exit
sap nt-a:sfp:1:100 create
exit
no shutdown
sap nt-a:sfp:1:100 create
eth-cfm
mip
exit
sap nt-a:sfp:2:100 create
exit
no shutdown
3HH-11985-AAAA-TQZZA
Virtual Private LAN Service
211