Table 478 Param-Problem Command - Nokia 7302 Manual

Virtual Private Routed Network Service
(2 of 2)
7.10.6.14
Table 478
488
Item Description
Description This command configures the rate for ICMP packet-too-big messages issued on the router
interface.
By default, generation of ICMP packet-too-big messages is enabled at a maximum rate of 100
per 10 second time interval.
The no form of this command disables the limiting the rate of packet-too-big on the router
interface.
Default packet-too-big 100 10
Parameters number — The maximum number of ICMP time-exceeded messages to send. This parameter
must be specified with the seconds parameter.
Values: 10 — 1000
seconds — The time frame in seconds used to limit the number of ICMP time-exceeded
messages that can be issued.
Values: 1 — 60
param-problem
param-problem command
Item Description
Syntax param-problem [number seconds]
no param-problem
Context configure>service>vprn>interface>ipv6>icmp6
Description This command configures the rate for ICMP param-problem messages issued on the router
interface.
By default, generation of ICMP param-problem messages is enabled at a maximum rate of 100
per 10 second time interval.
The no form of this command disables the limiting the rate of param-problem on the router
interface.
Default param-problem 100 10
Parameters number — The maximum number of ICMP param-problem messages to send. This parameter
must be specified with the seconds parameter.
Values: 10 — 1000
seconds — The time frame in seconds used to limit the number of ICMP param-problem
messages that can be issued.
Values: 1 — 60
3HH-11985-AAAA-TQZZA
FD 100/320Gbps NT and FX NT IHub Services Guide
Issue: 13