Table 444 Operational State; Table 445 Arp-Timeout Command; Arp-Timeout - Nokia 7302 Manual

FD 100/320Gbps NT and FX NT IHub Services Guide
Table 444
7.10.3.3
Table 445
7.10.3.4
Issue: 13
Operational State
Address
No address
No address
1.1.1.1
1.1.1.1

arp-timeout

arp-timeout command
Item Description
Syntax arp-timeout seconds
no arp-timeout
Context configure>service>vprn>interface
Description This command configures the minimum time, in seconds, an ARP entry learned on the IP
interface is stored in the ARP table. ARP entries are automatically refreshed for the below
scenarios:
•
When an ARP request or gratuitous ARP is seen from an IP host
•
If traffic is alive for this ARP then around the last 60 seconds of its timeout ARP will be
refreshed. This ARP refresh will not occur if arp-timeout is configured between 1 and 90
If the arp-timeout value is set to 0 seconds, ARP aging is disabled.
The no form of this command restores arp-timeout to the default value.
Default 14400 seconds
Parameters seconds — The minimum number of seconds a learned ARP entry will be stored in the ARP
table, expressed as a decimal integer. A value of zero specifies that the timer is inoperative
and learned ARP entries will not be aged.
Values: 0 — 65535
bfd
3HH-11985-AAAA-TQZZA
Virtual Private Routed Network Service
Administrative State
up
dowm
up
dowm
Operational State
dowm
dowm
up
dowm
471