Sony DVS-9000SF User Manual page 95

For an illustrative figure and other information, see "DME Special Effects" in
Chapter 1 (Volume 1).
Notes
• The Trail effect can be applied to two channels at the same time.
• Turning Trail on when Motion Decay or Keyframe Strobe is on turns it off
automatically.
Applying the Trail effect
Use the following procedure.
1
In the DME menu, select VF5 'Light/Trail' and HF2 'Trail.'
The Trail menu appears.
2
Press [Trail], turning it on.
The Trail effect is enabled. You can adjust the parameters with the knobs.
3
Set the parameters.
Knob
1
2
3
a) 0.00 is no trail. At 100.00, the trail does not disappear.
4
To erase the trail, press [Trail Eraser], turning it on.
Switching the priority between the current image and trail
superimposed
In the <Priority> group, select the method of superimposition.
Over: Current image is on top.
Under: Trail is on top.
Selecting the source to create a trail
In the <Trail Source> group, select the source to create a trail.
Freeze Video: Use freeze images of the input video as source of the trail.
Flat Color: Use a flat color matte as source of the trail. You can set the
following parameters with the knobs.
Parameter Adjustment
Decay Degree to which the trail is left
Interval Freeze interval
Live Proportion of the interval
between two successive freeze
images for which the video is
run
Setting values
a)
0.00 to 100.00
1 to 255 (frames)
0.00 to 100.00
DME Special Effect Operations
95