Sony DVS-9000SF User Manual page 279

3
In the <Trigger Type> group, select the trigger polarity.
(Rising Edge): The trigger causes the relay contacts to be open-
circuit or drives the output high, and holds this state for the
specified pulse width.
(Falling Edge): The trigger causes the relay contacts to be shorted
or drives the output low, and holds this state for the specified
pulse width.
: Each time the trigger occurs, the relay contacts are alternately
closed or opened, or the output is switched between high and
low.
Status: Depending on the status, the relay contacts are closed or opened,
or the output is switched between high and low.
No Operation: The trigger has no effect on the relay state or output level.
4
Turning the knobs, select the pulse width and timing to be set.
Knob Parameter
3 Pulse Width
4 Timing
a) 1: Field 1, 2: Field 2, 3: Any
When " " is selected as the trigger polarity, there is no Pulse Width
setting. When "Status" is selected, there is no Pulse Width or Timing
setting.
5
In the <Source> group, select the action block.
M/E-1 to M/E-3 and P/P: Set an action for the M/E or PGM/PST bank.
Common: Set an action for error status.
6
Using any of the following methods, select the action to be set.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
Knob Parameter
2 Action
5 Reg No
a) • Action list when the trigger type is other than "Status"
When Source is M/E-1, M/E-2, or M/E-3: Key1 SS ? Recall, Key2 SS ? Recall, Key3
SS ? Recall, Key4 SS ? Recall, No Action
When Source is P/P: DSK1 SS ? Recall, DSK2 SS ? Recall, DSK3 SS ? Recall, DSK
4 SS ? Recall, No Action
Adjustment
Pulse width
Output timing
Adjustment
Action selection
Register number
Setup Relating to Operations From the Control Panel
Setting values
1 to 60 (fields)
a)
1 to 3
Setting values
a)
1 to ...
b)
1 to 4
279