Sony DVS-9000SF User Manual page 252

3
To set a link table
For the link selected in the External Bus Link menu, make the settings as
follows.
1
2
3
4
To initialize the set links
Press [Init Link Table].
A confirmation message appears.
Press [Yes].
The links set using the above procedure are initialized to the default settings,
and this is reflected in the status area.
252
Setup Relating to Operations From the Control Panel
Knob Parameter Adjustment
3 Destination Destination start address
4 Level Level
To confirm a source address selected in step 2, press [Source Set] to
confirm a destination address press [Destination Set], and to confirm a
level press [Level Set].
This confirms the selection, which is reflected in the status area.
In the Panel>Config>External Bus Link>Link Matrix Adjust menu, press
[Link Table Adjust].
The Link Table Adjust menu appears.
The status area lists the status of the currently selected link, combinations
of video signals and sources, and the sources that can be selected.
Using any of the following methods, select the switcher cross-point button
and the matrix source to be linked to the button.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
Knob Parameter Adjustment
1 Main No Switcher cross-point button
2 Source No Matrix source selection
To confirm the matrix source selection made in step 2, press [Link Source
Set].
This confirms the selection, which is reflected in the status area.
As required, repeat steps 2 and 3 to select the matrix sources to be linked
to other cross-point buttons.
Setting values
1 to 897
1 to 8
Setting values
1 to 128
1 to 128