Sony DVS-9000SF User Manual page 297

2
Press [V Blank Mask].
3
Adjust the parameter.
Knob
2
a) Depending on the signal format, the adjustment range varies as follows.
• 480i: 10 to 19
• 576i: 6 to 22
To return the values to their defaults, press [Default].
4
To enable the through mode, press [Through Mode], setting it to Enable.
The through mode can be applied to the following outputs.
• AUX1 to 48 outputs
• Program outputs of the M/E and PGM/PST rows
• Clean outputs of the M/E and PGM/PST rows
Making safe title settings
Use the following procedure.
1
In the Switcher>Output menu, press [Safe Title].
The Safe Title menu appears.
The status area shows the output ports and the assigned signals, with the
box 1, box 2, and cross states.
2
To enable the safe title on/off setting made in the Misc menu, press [Safe
Title], turning it on.
3
Carry out either of the following operations.
To display a box: Press [Box1] or [Box2], turning it on.
In this case, carry out the following steps 4 and 5.
To display a cross: Press [Cross], turning it on.
4
When you selected [Box1] or [Box2] in step 3, adjust the following
parameters.
Knob
2
3
Parameter Adjustment
Mask End Final value for vertical blanking
interval
Parameter Adjustment
Box Size Box size
Luminance Display brightness
Setting values
a)
See note below
Setting values
50.00 to 100.00
0.00 to 100.00
Setup Relating to Switcher Processor
a)
297