Installation And Device Setup (Install/Unit Config Menu) - Sony DVS-9000SF User Manual

3
4

Installation and Device Setup (Install/Unit Config Menu)

To install software or firmware in a device, use the System>Install/Unit Config
menu.
To display the Install/Unit Config menu
In the Engineering Setup menu, select VF1 'System' and HF6 'Install/Unit
Config.'
The status area shows the version of the software installed in each device.
Installing software
Use the following procedure.
1
2
3
240
Setup for the Whole System
Press [Execute].
A confirmation message appears.
Select [Yes].
Depending on the selection in step 2, the following is the result.
• When you selected [Reset], a reset is applied to the device causing it to
be restarted in the start-up state.
• When you selected [All Clear], all memory in the device is cleared,
including snapshots, keyframe effects, setup, and so on, and the device
returns to its factory default settings. However, the Network Config,
Format, Start Up, and Date/Time settings are not initialized.
Insert the memory card holding the software into the memory card slot.
In the Install/Unit Config menu, press the [Install] button.
The System>Install/Unit Config>Install menu appears, showing a list of
the software contained in the memory card.
Using any of the following methods, select the device.
All: When this is on, all devices are selected for the operation.
Plural: When this is on, you can specify a number of devices to which the
operation will apply. In this case, in the status area, press the desired
devices, turning them to reverse video. To cancel a selection, press
once more to return to normal display.
When both of the above buttons are off: You can specify any device in
the status area.