Sony DVS-9000SF User Manual page 384

If you make both pre macro and post macro settings for the same
button
The later setting is valid.
To make a macro attachment setting in macro only mode
Note
To carry out this operation, it is first necessary to assign the "Macro Only Set"
function to the user preference buttons in the menu control block or the utility/
shotbox control operation. Carry out this assignment in the Eng
Setup>Panel>Prefs/Utility menu. (For details, see "Setting Button
Assignments (Prefs/Utility Menu)" (page 266).)
To make a macro attachment in Macro Only mode, use the following
procedure.
1
2
3
To check macro attachment settings
Hold down the [PRE MCRO] or [POST MCRO] button assigned to a utility/
shotbox control block button or user preference button. While this is held
down, the buttons for which a macro attachment is set flash as follows.
While the [PRE MCRO] button is held down:
While the [POST MCRO] button is held down:
Removing macro attachment settings
Hold down the [PRE MCRO] or [POST MCRO] button assigned to a utility/
shotbox control block button or user preference button, and press the
384
Macro Attachment Assigning
Recall the macro register you want to assign to the button.
For details of recall, see page 374.
Press the button to which [MCRO ONLY SET] is assigned, turning it on.
Hold down the [PRE MCRO] or [POST MCRO] button assigned to a
utility/shotbox control block button or user preference button, and press
the desired button in the background A row.
The cross-point button you pressed flashes green, and the register you
recalled in step 1 is assigned to the button. The [MCRO ONLY SET]
button goes off.
• Buttons set in pre macro mode: flash amber
• Buttons set in macro only mode: flash green
• Buttons set in post macro mode: flash amber
• Buttons set in macro only mode: flash green