Sony DVS-9000SF User Manual page 277

5
Using any of the following methods, select the action to be set.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
Knob Parameter
2 Action
5 Reg No
a) • Action list when the trigger type is other than "Level"
When Target is M/E-1, M/E-2, or M/E-3: Cut, Auto Trans
Key1 Cut, Key2 Cut, Key3 Cut, Key4 Cut
Key1 Auto Trans, Key2 Auto Trans, Key3 Auto Trans, Key4 Auto Trans
Key1 SS ? Recall, Key2 SS ? Recall, Key3 SS ? Recall, Key4 SS ? Recall
When Target is P/P: Cut, Auto Trans
DSK1 Cut, DSK2 Cut, DSK3 Cut, DSK4 Cut
DSK1 Auto Trans, DSK2 Auto Trans, DSK3 Auto Trans, DSK4 Auto Trans
DSK1 SS ? Recall, DSK2 SS ? Recall, DSK3 SS ? Recall, DSK4 SS ? Recall
FTB Cut, FTB Auto Trans
When Target is Common/Setup: Master SS ? Recall, Master Effect ? Recall, SS ?
Recall, Effect ? Recall, Effect ? Recall & Run, KF Run, KF Stop, KF Rewind, FM
Src1 Frame Freeze, FM Src1 Field Freeze, FM Src1 Freeze Off, FM Src2 Frame
Freeze, FM Src2 Field Freeze, FM Src2 Freeze Off, Shotbox ? Recall, Macro
Take, No Action
• Action list when the trigger type is only "Rising Edge" or "Falling Edge"
Aux? O'ride Src??
• Action list when the trigger type is "Level"
When Target is M/E-1, M/E-2, M/E-3, or P/P: No Action
When Target is Common/Setup: Format (Overall system settings, frame/field rate,
number of lines)
Aspect (overall system settings), Simul, Level Enable, No Action
Notes
• "Level Enable" is a function that determines whether GPI inputs are enabled
("Enable") or disabled ("Disable") for the "Aspect" and "Format" actions that can
be used when the trigger type is Level. When "Level Enable" is used, if the input is
"Disable" then it is not possible to switch "Aspect" or "Format" by GPI input.
If a GPI to switch "Aspect" or "Format" occurs when powering the system off, the
action triggered by the GPI may start immediately before the power goes off and
the power may go off before the action is completed. This may corrupt the setup
settings. It is therefore recommended to use "Level Enable" to avoid such a
situation.
• As for "Aux ? O'ride Src ??," when "Rising Edge" is selected, on a rising edge the
set AUX bus primary input is used. On a falling edge, the original state of the cross-
point is restored. If the GPI trigger is applied repeatedly at short intervals (0.5
second or less), the cross-point switching may not be carried out correctly. In this
case, apply the GPI trigger again.
b) When knob 2 selection is "Key Snapshot"
c) When knob 2 selection is "Snapshot"
d) When knob 2 selection is "Effect"
Adjustment
Action selection
Register number
Setup Relating to Operations From the Control Panel
Setting values
a)
1 to ...
b)
1 to 4
c)
1 to 99
d)
1 to 399
277