Sony DVS-9000SF User Manual page 147

6
Set the start point as a timecode value.
7
Press [Enter].
The new start point setting is reflected in the status area.
8
To set the stop point, in the <Stop TC> group press the [Set] button.
A timecode window appears.
9
Set the stop point as a timecode value.
If you do not want to set the stop point, skip to step 11.
10
Press [Enter].
The new stop point setting is reflected in the status area.
11
To set the variable speed, in the <Variable Speed> group, carry out any of
the following.
• Press [Fit].
Without setting a speed value, this automatically carries out playback
according to automatically calculated values for the duration and
keyframe duration to fit the set start point and stop point.
• Press the [Set] button, and adjust the parameter with the knob.
Knob Parameter
2 Variable
a) The setting range of the variable speed depends on the type of connected device.
The new variable speed setting is reflected in the status area.
Repeat steps 2 to 11 as required for other devices.
To carry out start point and stop point settings and cueing up
operations in the device control block
With the following buttons in the device control block, you can set the start
point or stop point of a keyframe point on the VTR/disk recorder timeline, or
carry out a cueing up operation.
Note
Check that the [MENU] button in the device control block is lit green. If it is
not lit, press it, turning it on.
[START TC] button: Set the start point of the keyframe point to the current
time.
Setting
Variable speed
Control of VTRs and Disk Recorders
Setting values
a)
–100 to +200
147