Sony DVS-9000SF User Manual page 450

Icon Title
GPI Input
GPI
Output
HDD
Format
HDD
Format
Install
450
Error Messages
Message
Please set Target.
Please set Trigger Type.
Please set Reg No.
Please set Aux Bus No.
Please set Src No.
Please set Pulse Width.
Please set Pulse Timing.
Please set Target.
Please set Trigger Type.
Please set Reg No.
Please set Aux Bus No.
Please set Src No.
Please set Pulse Width.
Please set Pulse Timing.
Failure.
HDD device is busy.
In order to complete HDD
format, System needs to be
restarted and formatted again.
System will be restarted, then
please execute HDD format
again.
Success!!
System will be restarted.
No Task.
Select a package on the list.
Description
7325.1/2: Engineering Setup>Panel>Device
Interface>GPI Input
7344.1/2: Engineering Setup>DME>Device
Interface>DME1 GPI Input
7344.5/6: Engineering Setup>DME>Device
Interface>DME2 GPI Input
7352/7352.1: Engineering Setup>DCU>GPI
Input Assign
In the above menus, when making a setting, a
parameter setting value was incorrect. Check
the settings, and try again.
7325.3/4: Engineering Setup>Panel>Device
Interface>GPI Output
7337.2/3: Engineering Setup>Switcher>Device
Interface>GPI Output
7337.4/5: Engineering Setup>Switcher>Device
Interface>GPI Output
7344.3/4: Engineering Setup>DME>Device
Interface>DME1 GPI Output
7344.7/8: Engineering Setup>DME>Device
Interface>DME2 GPI Output
7354/7354.1: Engineering Setup>DCU>GPI
Output Assign
In the above menus, when making a setting, a
parameter setting value was incorrect. Check
the settings, and try again.
7317: Engineering Setup>System>
Maintenance
In the above menu, the hard disk formatting
procedure failed.
If the hard disk is functioning correctly, or in
some cases when there is damage to the disk,
it may not be possible to format the disk
correctly in a single attempt. In such cases, it is
necessary to restart the system, and then carry
out formatting again.
Press [OK] to restart the system.
7317: Engineering Setup>System>
Maintenance
In the above menu, the hard disk formatting
procedure completed successfully.
Press [OK] to restart the system.
7316.5: Engineering Setup>System>Install/Unit
Config>Install
In the above menu, the package for installation
was not selected. Select a package to be
installed.