Table of Contents
Advertisement
Output (Standard display) mode
Use the Output (standard display) mode to read information on
the drive's status and to operate the drive. To go to the Output
mode, press EXIT until the LCD display shows status
information as described below.
Status information
Top. The top line of the LCD display shows the basic status
information of the drive.
•
HAND – Indicates that the drive control is local, i.e., from the
control panel (operator keypad).
•
AUTO – Indicates that the drive control is remote, such as
the basic I/O (X1) or fieldbus.
•
OFF – Indicates that the drive control is local and stopped.
•
– Indicates the drive and motor rotation status as follows:
Control panel display
Rotating arrow (clockwise or
counterclockwise)
Dotted rotating arrow
Stationary arrow
Dotted stationary arrow
•
Upper right – shows the active reference.
Centre. Using parameter
PANEL
DISPLAY, the centre of the
LCD display can be configured to
display:
•
Three signals from
OPERATING DATA
0103 (
OUTPUT FREQ
and 0120 (
•
Two signals from
parameters are selected to be indicated, also the names of
the parameters are displayed.
72
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Group 34:
Group 01:
– The default display shows parameters
) in hertz, 0104 (
1) as a percentage.
AI
Group 01: OPERATING DATA
ACH550-01 User's Manual
Significance
• Drive is running and at
setpoint.
• Shaft direction is forward
or reverse.
Drive is running but not at
setpoint.
Drive is stopped.
Start command is present, but
the motor is not running, e.g.
because start enable is
missing.
AUTO
15.
3.
44.
00:00
) in amperes
CURRENT
Start-up and control panel
15.0Hz
0 Hz
7 A
0 %
MENU
– If only two
Advertisement
Table of Contents
