Rb - Resume Breakpoint - GE 68K System User Manual

GE Energy Services

RB - Resume Breakpoint

þ
CPM
Platform
Use this command to restart a process that stopped at a breakpoint, without removing
Description
the breakpoint.
It verifies the specified breakpoint, restarts the associated process, and then reinserts
the breakpoint trap.
Syntax Below is usage and syntax information for this command
Command Format
Variables
Parameters
Example
Special
Considerations
3-56
þ o
D20 D20 ME
D20 Base D20 Base
rb break_pt# [#reps]
None
break_pt# = breakpoint number as returned with the define
#reps = number of times (in decimal) to repeat
Type rb 1 and press
This resumes breakpoint number one (1) that stops again
before the second execution of the instruction at the breakpoint
address.
Results: The system responds with the prompt. Whenever it
encounters a breakpoint, the system displays the
breakpoint number, loop count, and register values.
If the loop count is greater than zero, it is
decremented. Otherwise, the process is suspended.
None
SWM0023 1.00 2
o þ
D20/200
CCU Base
breakpoint command.
execution of the breakpoint address before
stopping; default is zero.
.
ENTER
68K System Monitor
User's Guide
þ
D20/200 ME D25
CCU Base
General
Full Release