Jx - Jam Exchange - GE 68K System User Manual

68K System Monitor
User's Guide

JX - Jam Exchange

þ
CPM
Platform
Use this command to force a message to the beginning of the message queue at one
Description
or more exchanges.
Below is usage and syntax information for this command
Syntax
Command Format
Variables
Parameters
Example
Special
Considerations
General
Full Release
þ þ
D20 D20 ME
D20 Base D20 Base
CPM / D20 / D25:
CCU / CCUME:
/g = Allows the message to be jammed into a queue in
a different node
xid = pSOS exchange ID (in hexadecimal); send
message to a specific exchange.
gxid = global exchange ID (in hexadecimal); send
message to a specific exchange.
name = case-sensitive exchange name. The command
supports the new exchange naming convention. If
you enter an entire name, the monitor sends the
message to that exchange. If you enter the first
few characters, the command attempts pattern
matching. It sends the message to one or more
exchanges depending on the number of matches.
m2 - m5 = first through fourth long words in the body of the
message, in hexadecimal.
Type jx 304540 1 2 3 4 and press
This sends a message to an exchange identified as 304540. The
command sets the first two reserved messages to 0.
Results: Unless it encounters an error, the system displays the
prompt. In the case of an error, it displays an error
message before the prompt.
You must only use this command in a testing or debugging
context. If you send an indiscriminate message to an exchange,
you cannot predict the results.
SWM0023-1.00 -2
þ þ
D20/200 D20/200 ME
CCU Base CCU Base
jx (xid | name) m2 m3 m4 m5
jx (xid | gxid | name) m2 m3 m4 m5 [/g]
.
ENTER
GE Energy Services
þ
D25
3-43