Ht - Hdlc Test - GE 68K System User Manual

GE Energy Services

HT - HDLC Test

o
CPM
Platform
Use this command to transmit specific application messages over the HDLC
Description
communication link.
Note:
Syntax Below is usage and syntax information for this command
Command Format
Variables
Parameters
Example
Special
Considerations
3-40
þ þ
D20 D20 ME
D20 Base D20 Base
Because you must assemble these messages by hand, you can not use the
command effectively unless you know the protocol used by the D.20
application.
ht /(c | m | r | s | w)
/c =
/m =
/r =
/s =
/w =
None
None required
This command is not available on the CPM.
This command is not available if the D.20 (B003) application
is active.
SWM0023 1.00 2
o þ
D20/200
CCU Base
configure the link parameters
define the application message
read (monitor) the link
display configuration status
send an application message
68K System Monitor
User's Guide
o
D20/200 ME D25
CCU Base
General
Full Release