Erase - Flash Erase - GE 68K System User Manual

GE Energy Services

ERASE - Flash Erase

o
CPM
Platform
Note:
Description
Use this command to perform an erase of the Flash memory region, resetting all
bytes in Flash to 0xFF in preparation for application data download.
Syntax Below is usage and syntax information for this command
Command Format
Variables
Parameters
Example
Special
Considerations
Executing this command modifies RTU memory and will cause operational
!
disruption (specifically by destroying all Flash application code).
Do not use this command unless you are prepared to perform a code download
WARNING
procedure.
Use caution before proceeding.
3-34
o þ
D20 D20 ME
D20 Base D20 Base
this command is available only when executing from the BootROM. This
will be indicated by the D25A>, or the D20MEA> prompts for the D25 or
D20ME-based systems, respectively.
D25:
D20 ME / CCUME:
None
/d =
/y =
Type erase and press
Results: If you confirm the erase prompt, the command erases
the Flash EPROM.
The command prompt will return if Flash is already clear when
the erase command is invoked. Otherwise, the command
prompts the user to confirm the Flash erase.
If you enter any response other than "y", the command aborts
the erase.
SWM0023 1.00 2
o þ
D20/200
CCU Base
erase [/d /y]
erase [/y]
erase DSP Flash
disable the verification prompts
.
ENTER
68K System Monitor
User's Guide
þ
D20/200 ME D25
CCU Base
General
Full Release