Table of Contents
Advertisement
68K System Monitor
User's Guide
Error Messages
68K Monitor returns several general error messages resulting from input or syntax
Introduction
errors in the command input, or system or test failures during execution.
These error messages are identified below:
The most general error is an incorrect number of arguments for the command
Message
Summary
defined. This error causes a display of the correct use of the specified function.
Other possible error messages are listed below:
Application which
activated the monitor
has been deleted! (or
suspended)
Breakpoint defined!
Breakpoint not
suspended!
Cannot post to
exchange!
Command aborted!
Command not found!
FLASH invalid!
Invalid ID!
Invalid switch!
No free breakpoints!
Numeric input error!
General
Full Release
This Message
a process or user requests an exit command, but the
process that called 68K Monitor is suspended or
deleted.
the specified address is already defined as a breakpoint,
the monitor will display this message when defining a
new breakpoint (DB).
a breakpoint was not encountered when attempting a
resume (RB) or step (SB) breakpoint command.
a send (SX) or jam (JX) exchange command encounters
an error in sending the message to the specified
exchange.
the user replied NO when asked to verify a Return to
BootROM (RTB) command.
the specified command is not located within 68K
Monitor's command list.
a directory (DIR) command on a FLASH default
database fails (i.e., no default database could be
detected).
the monitor cannot find the specified identification, or it
is incorrect. The ID can be a breakpoint number,
communications port, table name, or process or
exchange ID
the user does not specify the mode for the chosen
function.
the define breakpoint (DB) command is attempted when
all available breakpoints are in use.
a numeric field contains non-numeric characters.
SWM0023-1.00 -2
is displayed when...
Continued on next page
GE Energy Services
1-7
Hide quick links:
Advertisement
Table of Contents
