Sx - Send Exchange - GE 68K System User Manual

GE Energy Services

SX - Send Exchange

þ
CPM
Platform
Use this command to queue a message at one or more exchanges.
Description
Below is usage and syntax information for this command
Syntax
Command Format
Variables
Parameters
Example
Special
Considerations
3-76
þ þ
D20 D20 ME
D20 Base D20 Base
CPM / D20 / D25:
CCU / CCUME:
/g = Allows the message to be sent to a queue in a
different node
xid = pSOS exchange ID (in hexadecimal); send
message to a specific exchange.
gxid = global pSOS exchange ID (in hexadecimal); send
message to a specific exchange.
name = case-sensitive exchange name. The command
supports the new exchange naming convention.
If you enter an entire name, the system sends the
message to that exchange.
If you enter the first few characters, the
command attempts pattern matching. The system
sends the message to one or more exchanges,
depending on the number of matches.
m2 - m5 = first through fourth long words in the body of the
message, in hexadecimal.
Type sx 304540 1 2 3 4 and press
This sends a message identified as 304540. The command sets
the first two reserved messages to 0.
Results: The system displays the prompt unless it encounters
an error. In this case, it displays an error message
before displaying the prompt.
You must only use this command in a testing or debugging
context. If you send a message to an exchange
indiscriminately, you cannot predict the results.
SWM0023 1.00 2
68K System Monitor
þ þ
D20/200 D20/200 ME
CCU Base CCU Base
sx (xid | name) m2 m3 m4 m5
sx (xid | gxid | name) m2 m3 m4 m5 [/g]
.
ENTER
User's Guide
þ
D25
General
Full Release