D - Dump Memory - GE 68K System User Manual

68K System Monitor
User's Guide

D - Dump Memory

þ
CPM
Platform
Use this command to display memory contents as bytes, words, long words, floating-
Description
point numbers, or double-precision numbers.
Each line of output is formatted as:
at the left margin:
−
then:
−
•
bytes
•
words
•
long words
•
floating-point numbers
•
double-precision numbers
then:
−
If an octet does not have a printable ASCII representation, the monitor will print a
dot instead.
Below is usage and syntax information for this command
Syntax
Command Format
Variables
Parameters
General
Full Release
þ þ
D20 D20 ME
D20 Base D20 Base
starting address of the memory, hexadecimal.
16 bytes (octets) of data grouped as:
16 ASCII characters representing the same memory values.
d [/(b | w | l | f | d)] beg_addr [end_addr]
/b =
/w =
/l =
/f =
/d =
By not entering any parameters, the command requests a dump
from the last user-entered memory dump location. The dump is
in the previously specified format (if any) and dumps for 80
bytes.
beg_addr =
end_addr =
SWM0023-1.00 -2
þ þ
D20/200
CCU Base
−
hexadecimal format
−
hexadecimal format
−
hexadecimal format
−
scientific format
−
scientific format
bytes (octets), the default mode
words
long words
floating-point numbers
double-precision numbers
first address to display, in hexadecimal.
address up to which to display, in hexadecimal;
the default is beg_addr plus 80 hexadecimal.
GE Energy Services
þ
D20/200 ME D25
CCU Base
Continued on next page
3-19