Clearing Xlates - Cisco 4700M Configuration Manual

Clearing Xlates

Clearing Xlates
Cisco 4700 Series Application Control Engine Appliance Security Configuration Guide
5-44
host1/Admin# show conn
total current connections : 2
conn-id dir prot vlan source
----------+---+----+----+------------------+------------------+------+
6 in TCP
7 out TCP
You can clear the global address-to-local address mapping information based on
the global address, the global port, the local address, the local port, the interface
address as the global address, and the NAT type by using the clear xlate command
in Exec mode. When you enter this command, the ACE releases sessions that are
using the translations (Xlates). The syntax of this command is as follows:
clear xlate [{global | local} start_ip [end_ip [netmask netmask]]] [{gport |
lport} start_port [end_port]] [interface vlan number] [state static]
[portmap]
The keyword, arguments, and options are as follows:
global—(Optional) Clears the active translation by the global IP address.
•
local—(Optional) Clears the active translation by the local IP address.
•
start_ip—Global or local IP address in a global or local range of IP addresses.
•
Enter an IP address in dotted-decimal notation (for example, 172.27.16.10).
end_ip—(Optional) Last IP address in a global or local range of IP addresses.
•
Enter an IP address in dotted-decimal notation (for example, 172.27.16.10).
netmask netmask—(Optional) Specifies the network mask for global or local
•
IP addresses. Enter a mask in dotted-decimal notation (for example,
255.255.255.0).
gport—(Optional) Clears active translations by the global port.
•
lport—(Optional) Clears active translations by the local port.
•
start_port—Global or local port number.
•
end_port—(Optional) Last port number in a global or local range of ports.
•
Chapter 5
2021 192.168.0.10:37766 192.168.211.1:3030 ESTAB
2020 172.27.0.5:23
Configuring Network Address Translation
destination
192.168.0.10:1025
state
ESTAB
OL-16202-01