Configuring Dynamic Nat And Pat; Dynamic Nat And Pat Configuration Quick Start - Cisco 4700M Configuration Manual

Chapter 5 Configuring Network Address Translation

Configuring Dynamic NAT and PAT

Dynamic NAT and PAT Configuration Quick Start

OL-16202-01
For example, to specify an idle timeout of 120 seconds (2 minutes), enter:
host1/Admin(config)# timeout xlate 120
To reset the NAT idle timeout to the default value of 10800 seconds, enter:
host1/Admin(config)# no timeout xlate 120
This section describes how to configure dynamic NAT and PAT on an ACE for
SNAT. For overview information about dynamic NAT and dynamic PAT, see the
"Network Address Translation Overview"
following topics:
Dynamic NAT and PAT Configuration Quick Start
•
Configuring an ACL
•
Configuring Interfaces for Dynamic NAT and PAT
•
Creating a Global IP Address Pool for NAT
•
• Configuring a Class Map
Configuring a Policy Map
•
Configuring Dynamic NAT and PAT as a Layer 3 and Layer 4 Policy-Map
•
Action
Applying the Dynamic NAT and PAT Policy Map to an Interface Using a
•
Service Policy
Table 5-1 provides a quick overview of the steps required to configure dynamic
NAT and PAT. Each step includes the CLI command or a reference to the
procedure required to complete the task. For a complete description of each
feature and all the options associated with the CLI commands, see the sections
following Table 5-1.
Cisco 4700 Series Application Control Engine Appliance Security Configuration Guide
Configuring Dynamic NAT and PAT
section. This section contains the
5-9