Configuring a Connection Parameter Map for TCP/IP Normalization and Termination
Configuring a Connection Parameter Map for TCP/IP
Normalization and Termination
Cisco 4700 Series Application Control Engine Appliance Security Configuration Guide
4-6
Chapter 4
You can configure a parameter map to group TCP/IP connection-related
commands that apply to normalization and termination. After you configure the
parameter map, associate it with a specific action statement in a policy map using
the connection tcp advanced-options command. For details about associating a
parameter map with a policy map, see the
Map with a Policy Map"
Creating a Connection Parameter Map for TCP/IP, UDP, and ICMP
•
Configuring Rate Limits for a Policy Map
•
Setting the Maximum Receive or Transmit Buffer Share
•
•
Setting a Range for the Maximum Segment Size
Configuring ACE Behavior for a Segment That Exceeds the Maximum
•
Segment Size
Setting the Maximum Number of TCP SYN Retries
•
Enabling Nagle's Algorithm
•
Enabling Random TCP Sequence Numbers
•
Configuring How the ACE Handles Reserved Bits
•
Configuring the Timeout for an Embryonic Connection
•
Configuring the Timeout for a Half-Closed Connection
•
Configuring the Connection Inactivity Timeout
•
Setting How the ACE Applies TCP Optimizations to Packets
•
Setting the Window Scale Factor
•
Enabling the TCP Slow Start Algorithm
•
Setting the ACK Delay Timer
•
Configuring How the ACE Handles TCP SYN Segments that Contain Data
•
Configuring How the ACE Handles TCP Options
•
Setting the Urgent Pointer Policy
•
Setting the Type of Service
•
Configuring TCP/IP Normalization and IP Reassembly Parameters
"Associating a Connection Parameter
section. This section contains the following topics:
OL-16202-01