Cisco 4700M Configuration Manual page 301

Chapter 4 Configuring TCP/IP Normalization and IP Reassembly Parameters
Table 4-6
Task and Command Example
3.
4.
5.
6.
7.
8.
Cisco 4700 Series Application Control Engine Appliance Security Configuration Guide
OL-16202-01
IP Fragment Reassembly Configuration Quick Start (continued)
Enter interface configuration mode for the interface on which you want to
configure fragment reassembly parameters.
host1/C1(config)# interface vlan 100
host1/C1(config-if)#
Configure the maximum number of fragments belonging to the same packet
that the ACE accepts for reassembly.
host1/C1(config-if)# fragment chain 126
Configure the minimum fragment size that the ACE will accept for
reassembly.
host1/C1(config-if)# fragment min-mtu 1024
Configure a fragment reassembly timeout to specify the period of time after
which the ACE abandons the fragment reassembly process if it does not
receive any outstanding fragments for the current fragment chain
(fragments that belong to the same packet).
host1/C1(config-if)# fragment timeout 15
(Optional) Save your configuration changes to flash memory.
host1/C1# copy running-config startup-config
Display the IP fragment reassembly configuration information.
host1/C1# show interface vlan 100
Configuring IP Fragment Reassembly Parameters
4-43