Cisco 4700M Configuration Manual page 263

Chapter 4 Configuring TCP/IP Normalization and IP Reassembly Parameters
Table 4-1
Task and Command Example
7.
8.
9.
10.
11.
Cisco 4700 Series Application Control Engine Appliance Security Configuration Guide
OL-16202-01
TCP/IP Normalization and Termination Configuration Quick
Start (continued)
Associate the connection parameter map as an action in the TCP/IP policy
map.
host1/C1(config-pmap-c)# connection advanced-options
TCPIP_PARAM_MAP
host1/C1(config-pmap-c)# exit
host1/C1(config-pmap)# exit
Apply the policy map globally across all interfaces in the context using a
service policy.
host1/C1(config)# interface vlan 50
host1/C1(config-if)# service-policy input TCPIP_POLICY
host1/C1(config-if)# exit
Configure additional IP normalization parameters in interface configuration
mode.
host1/C1(config-if)# ip ttl 15
host1/C1(config-if)# ip options clear
host1/C1(config-if)# ip df allow
host1/C1(config-if)# exit
host1/C1(config)# exit
(Optional) Save your configuration changes to flash memory.
host1/C1# copy running-config startup-config
Display the TCP/IP normalization configuration information.
host1/C1# show running-config policy-map
host1/C1# show running-config parameter-map
host1/C1# show running-config interface
host1/C1# show service-policy name
TCP/IP Normalization and Termination Configuration Quick Start
4-5