Configuring Server Farm-Based Dynamic NAT
Configuring Server Farm-Based Dynamic NAT
Server Farm-Based Dynamic NAT Configuration Quick Start
Cisco 4700 Series Application Control Engine Appliance Security Configuration Guide
5-20
This section describes how to configure server farm-based dynamic NAT on an
ACE for SNAT. For overview information about server farm-based dynamic NAT,
see the
"Network Address Translation Overview"
the following topics:
Server Farm-Based Dynamic NAT Configuration Quick Start
•
•
Configuring an ACL for Server Farm-Based Dynamic NAT
Configuring Interfaces for Server Farm-Based Dynamic NAT
•
Creating a Global IP Address Pool for Dynamic NAT
•
Configuring Real Servers and a Server Farm
•
Configuring a Layer 7 Load-Balancing Class Map for Server Farm-Based
•
Dynamic NAT
Configuring a Layer 7 Load-Balancing Policy Map for Server Farm-Based
•
Dynamic NAT
Configuring Server Farm-Based Dynamic NAT as a Layer 7 Policy Action
•
Configuring a Layer 3 and Layer 4 Class Map for Server Farm-Based
•
Dynamic NAT
Configuring a Layer 3 and Layer 4 Policy Map for Server Farm-Based
•
Dynamic NAT
Applying the Layer 3 and Layer 4 Policy Map to an Interface Using a Service
•
Policy
Table 5-2
provides a quick overview of the steps required to configure server
farm-based dynamic NAT. Each step includes the CLI command or a reference to
the procedure required to complete the task. For a complete description of each
feature and all the options associated with the CLI commands, see the sections
following
Table
5-2.
Chapter 5
Configuring Network Address Translation
section. This section contains
OL-16202-01