Cisco 4700M Configuration Manual page 79

Chapter 2 Configuring Authentication and Accounting Services
Table 2-1
Task and Command Example
1.
2.
3.
4.
Cisco 4700 Series Application Control Engine Appliance Security Configuration Guide
OL-16202-01
Authentication and Accounting Configuration Quick Start
Configure the authentication and accounting service settings on the
TACACS+, RADIUS, or LDAP server.
If you are operating in multiple contexts, observe the CLI prompt to verify
that you are operating in the desired context. If necessary, log directly in to,
or change to, the correct context.
host1/Admin# changeto C1
host1/C1#
The rest of the examples in this table use the Admin context, unless
otherwise specified. For details on creating contexts and user accounts to
provide access to the local database on the ACE for CLI access
authentication, see the Cisco 4700 Series Application Control Engine
Appliance Virtualization Configuration Guide.
Enter configuration mode by entering config.
host1/Admin# config
Enter configuration commands, one per line. End with CNTL/Z
host1/Admin(config)#
Configure the individual AAA server parameters. For example, to configure
RADIUS server authentication parameters, enter:
host1/Admin(config)# radius-server host 192.168.2.3 key HostKey
host1/Admin(config)# radius-server host 192.168.2.3 key 7
secret_1256
host1/Admin(config)# radius-server host 192.168.2.3 auth-port
1645
host1/Admin(config)# radius-server host 192.168.2.3 acct-port
1646
host1/Admin(config)# radius-server host 192.168.2.3
authentication
host1/Admin(config)# radius-server host 192.168.2.3 accounting
host1/Admin(config)# radius-server host 192.168.2.3 timeout 25
host1/Admin(config)# radius-server host 192.168.2.3 retransmit 3
Authentication and Accounting Configuration Quick Start
2-9