Configuring Ip Fragment Reassembly Parameters; Ip Fragment Reassembly Configuration Quick Start - Cisco 4700M Configuration Manual

Configuring IP Fragment Reassembly Parameters

Configuring IP Fragment Reassembly Parameters

IP Fragment Reassembly Configuration Quick Start

Cisco 4700 Series Application Control Engine Appliance Security Configuration Guide
4-42
Chapter 4
You can configure several parameters that control how the ACE performs IP
fragment reassembly. This section contains the following topics:
IP Fragment Reassembly Configuration Quick Start
•
Configuring the MTU for an Interface
•
Configuring the Maximum Number of Fragments in a Packet
•
Configuring the Minimum Fragment Size for Reassembly
•
• Configuring an IP Reassembly Timeout
Table 4-6 provides a quick overview of the steps required to configure IP fragment
reassembly. Each step includes the CLI command or a reference to the procedure
required to complete the task. For a complete description of each feature and all
the options associated with the CLI commands, see the sections following
Table 4-6.
Table 4-6 IP Fragment Reassembly Configuration Quick Start
Task and Command Example
If you are operating in multiple contexts, observe the CLI prompt to verify
1.
that you are operating in the desired context. If necessary, change to the
correct context.
host1/Admin# changeto C1
host1/C1#
The rest of the examples in this table use the C1 context, unless otherwise
specified. For details on creating contexts, see the Cisco 4700 Series
Application Control Engine Appliance Virtualization Configuration Guide.
Enter configuration mode.
2.
host1/C1# config
host1/C1(config)#
Configuring TCP/IP Normalization and IP Reassembly Parameters
OL-16202-01