Configuring A Traffic Policy For Tcp/Ip Normalization And Termination; Configuring A Layer 4 Class Map - Cisco 4700M Configuration Manual

Configuring a Traffic Policy for TCP/IP Normalization and Termination

Configuring a Traffic Policy for TCP/IP Normalization
and Termination

Configuring a Layer 4 Class Map

Cisco 4700 Series Application Control Engine Appliance Security Configuration Guide
4-26
Chapter 4
This section describes how to configure a traffic policy for TCP/IP normalization
and termination and contains the following topics:
Configuring a Layer 4 Class Map
•
Configuring a Layer 3 and Layer 4 Policy Map
•
Associating a Connection Parameter Map with a Policy Map
•
Associating a Layer 3 and Layer 4 Policy Map with a Service Policy
•
You can use a Layer 4 class map to classify network traffic for TCP/IP
normalization and termination. To match the traffic class, the network traffic must
satisfy the match criteria that you specify in the class map.
To configure a class map for TCP/IP normalization and termination, use the
class-map command in configuration mode. For details about configuring a class
map, see the Cisco 4700 Series Application Control Engine Appliance
Administration Guide.
The syntax of this command is as follows:
class-map [match-all | match-any] name
The keywords, arguments, and options are as follows:
match-all | match-any—(Optional) Determines how the ACE evaluates
•
Layer 4 network traffic when multiple match criteria exist in a class map. The
class map is considered a match if the match commands meet one of the
following conditions.
match-all—(Default) To match the traffic class, network traffic must
–
satisfy all the match criteria listed in the class map, typically, match
commands of different types.
match-any—To match the traffic class, network traffic must match only
–
one of the match criteria listed in the class map, typically, match
commands of the same type.
Configuring TCP/IP Normalization and IP Reassembly Parameters
OL-16202-01