Displaying Tcp Statistics - Cisco 4700M Configuration Manual

Chapter 4 Configuring TCP/IP Normalization and IP Reassembly Parameters
Displaying Configurations and Statistics for TCP/IP and UDP Connections, IP Reassembly, and SYN Cookie

Displaying TCP Statistics

OL-16202-01
Table 4-11 describes the fields in the show fragment command output.
Table 4-11 Field Descriptions for the show fragment Command Output
Field Description
Interface VLAN ID of the interface.
Fragment Stats
Required Number of packets that were sent to the ACE for
fragmentation.
OK Number of fragments that the ACE successfully created.
Failed Number of fragmentation attempts that were unsuccessful.
Created Total number of fragments that the ACE created.
IP Reassembly Stats
Required Number of packets that were sent to the ACE for reassembly.
OK Number of packets that the ACE successfully reassembled.
Failed Number of packet reassembly attempts that were
unsuccessful.
You can display TCP statistics by using the show tcp statistics command in Exec
mode. This command display statistics for traffic destined to the ACE, rather than
through the ACE. The syntax of this command is as follows:
show tcp statistics
For example, to display TCP statistics for the current context, enter:
host1/C1# show tcp statistics
Cisco 4700 Series Application Control Engine Appliance Security Configuration Guide
4-59