Information; Viewing Application Protocol Inspection Statistics And Service Policy Information; Displaying Http Protocol Inspection Statistics - Cisco 4700M Configuration Manual

Chapter 3 Configuring Application Protocol Inspection
Viewing Application Protocol Inspection Statistics
and Service Policy Information

Displaying HTTP Protocol Inspection Statistics

OL-16202-01

Viewing Application Protocol Inspection Statistics and Service Policy Information

interface vlan 70
ip address 192.168.2.1 255.255.255.0
access-group input ACL1
service-policy input L4_DNS-INSPECT_POLICY
no shutdown
The ACE CLI provides a comprehensive set of show commands that display
application protocol inspection statistics and service policy configuration
information. This section contains the following topics:
Displaying HTTP Protocol Inspection Statistics
•
Displaying Service Policy Configuration Information
•
You can display FTP, HTTP, or RTSP protocol inspection statistics by using the show
stats inspect command. The syntax of this command is as follows:
show stats inspect [ftp | http | rtsp]
For example, enter:
host1/Admin# show stats inspect http
+------------------------------------------+
+--------- HTTP Inspect statistics --------+
+------------------------------------------+
Total request/response
Total allow decisions
Total drop decisions
Total logging decisions
Use the clear stats inspect command to clear the HTTP protocol inspection
statistics.
Table 3-9 describes the fields in the show stats inspect command output.
Cisco 4700 Series Application Control Engine Appliance Security Configuration Guide
: 0
: 0
: 0
: 0
3-129