Cisco 4700M Configuration Manual page 345

Chapter 5 Configuring Network Address Translation
•
For example, to apply a service policy to a specific interface, enter:
host1/C1(config)# interface vlan 100
host1/C1(config-if)# mtu 1700
host1/C1(config-if)# ip address 192.168.1.100 255.255.255.0
host1/C1(config-if)# service-policy input NAT_POLICY
To apply a service policy globally to all interfaces in a context, enter:
host1/C1(config)# service-policy input NAT_POLICY
To remove a service policy from an interface, enter:
host1/C1(config-if)# no service-policy input NAT_POLICY
To remove a service policy globally from all interfaces in a context, enter:
host1/C1(config)# no service-policy input NAT_POLICY
When you detach a traffic policy either individually from the last VLAN interface
Note
on which you applied the service policy or globally from all VLAN interfaces in
the same context, the ACE automatically resets the associated service-policy
statistics. The ACE performs this action to provide a new starting point for the
service-policy statistics the next time that you attach a traffic policy to a specific
VLAN interface or globally to all VLAN interfaces in the same context.
Cisco 4700 Series Application Control Engine Appliance Security Configuration Guide
OL-16202-01
policy_name—Name of a previously defined policy map. The name can have
a maximum of 64 alphanumeric characters.
Configuring Dynamic NAT and PAT
5-19