Displaying Service Policy Statistics - Cisco 4700M Configuration Manual

Chapter 4 Configuring TCP/IP Normalization and IP Reassembly Parameters
Displaying Configurations and Statistics for TCP/IP and UDP Connections, IP Reassembly, and SYN Cookie

Displaying Service Policy Statistics

.
OL-16202-01
You can display service-policy statistics by using the show service-policy
command in Exec mode. The syntax of this command is as follows:
show service-policy name
The name argument is a unique identifier for an existing service policy, specified
as an unquoted text string with a maximum of 64 alphanumeric characters.
For example, to display service-policy statistics for the current context, enter:
host1/C1# show service-policy POLICY1
Table 4-14 describes the fields in the show service-policy command output.
Table 4-14 Field Descriptions for the show service-policy Command
Output
Field Description
Interface VLAN identifier of the interface associated with the service
policy.
Service-Policy Identifier of the service policy.
Class Identifier of the class map associated with the service policy.
Loadbalance
L7 Identifier of the Layer 7 load-balancing policy map
Loadbalance associated with the service policy.
Policy
VIP Route Configured distance metric for the route that needs to be
Metric entered in the routing table.
VIP Route State of route health injection (RHI) using the loadbalance
Advertise vip advertise command. Possible values are ENABLED or
DISABLED.
VIP ICMP State of the VIP's ability to reply to ICMP requests. Possible
Reply values are ENABLED or DISABLED.
VIP State Current status of the virtual IP address. Possible values are
INSERVICE or OUTOFSERVICE.
Curr Conns Number of active connections.
Cisco 4700 Series Application Control Engine Appliance Security Configuration Guide
4-61