Cisco 4700M Configuration Manual page 311

Chapter 4 Configuring TCP/IP Normalization and IP Reassembly Parameters
Displaying Configurations and Statistics for TCP/IP and UDP Connections, IP Reassembly, and SYN Cookie
Table 4-8
Table 4-8
Field
Total Current
Connections
Conn-ID
NP
Dir
Prot
VLAN
Source
Destination
State
Idle Time
Byte Count
Elapsed Time
Packet Count
Conn in Reuse
Pool
Cisco 4700 Series Application Control Engine Appliance Security Configuration Guide
OL-16202-01
describes the fields in the show conn detail command output.
Field Descriptions for the show conn detail Command Output
Description
Total number of current connections to the ACE.
The total current connections is the number of
Note
connection objects. There are two connection
objects for each flow and complete connection.
Identifier of the inbound or outbound connection.
Number of the network processor (NP) responsible for the
connection.
Direction of the connection: in(bound) or out(bound).
Protocol used for the connection: TCP or UDP.
Identifier of the interface used for the connection.
Source IP address and port.
Destination IP address and port.
For TCP connections, the current state of the connection (for
example, ESTAB).
Length of time that this connection has been idle.
Number of bytes that have traversed the connection.
Length of time that has elapsed since the connection was
established.
Number of packets that have traversed the connection.
Indication of whether the ACE has placed the connection in
the pool for possible reuse. Valid values are TRUE or
FALSE.
4-53