Policy - Cisco 4700M Configuration Manual

Configuring a Layer 3 and Layer 4 Application Protocol Inspection Traffic Policy
Adding a Layer 3 and Layer 4 Policy Map Description
Specifying a Layer 3 and Layer 4 Traffic Class with the Traffic Policy
Cisco 4700 Series Application Control Engine Appliance Security Configuration Guide
3-100
You can use the description command to provide a brief summary of the Layer 3
and Layer 4 policy map. You must access the policy map configuration mode to
specify the description command.
The syntax of this command is as follows:
description text
The text argument is an unquoted text string with a maximum of
240 alphanumeric characters.
For example, to specify a description that the policy map is to perform DNS
application protocol inspection, enter:
host1/Admin(config-pmap)# description DNS application protocol
inspection of incoming traffic
To remove the description from the policy map, enter:
host1/Admin(config-pmap)# no description
You can specify a traffic class created with the class-map command to associate
network traffic with the traffic policy by using the class command.
The syntax of this command is as follows:
class map_name
The map_name argument is the name of a previously defined traffic class,
configured with the class-map command, to associate traffic to the traffic policy.
Enter an unquoted text string with no spaces and a maximum of 64 alphanumeric
characters.
The CLI displays the policy map class configuration mode.
For example, to specify an existing class map within the Layer 3 and Layer 4
policy map, enter:
host1/Admin(config-pmap)# class HTTP_INSPECT_L4CLASS
host1/Admin(config-pmap-c)#
To remove a class map from a Layer 3 and Layer 4 policy map, enter:
Chapter 3 Configuring Application Protocol Inspection
OL-16202-01