Cisco 4700M Configuration Manual page 37

Chapter 1 Configuring Security Access Control Lists
Table 1-4
Keyword
tacacs
talk
tftp
time
who
wsp
wsp-wtls
wsp-wtp
wsp-wtp-wtls
xdmcp
•
•
•
•
Cisco 4700 Series Application Control Engine Appliance Security Configuration Guide
OL-16202-01
Well-Known UDP Key Words and Port Numbers (continued)
Port
Number
49
517
69
37
513
9200
9202
9201
9203
177
dest_ip_address netmask—IP address of the network or host to which the
packet is being sent and the network mask bits to be applied to the destination
IP address. Use these arguments to specify a range of destination IP
addresses.
any—Specifies the network traffic that goes to any destination.
host dest_address—Specifies the IP address and subnet mask of the
destination of the packets in a flow. Use this keyword and argument to specify
the network traffic destined to a single IP address.
operator—(Optional) Operand used to compare source and destination port
numbers for TCP and UDP protocols. The operators are as follows:
lt—Less than.
–
gt—Greater than.
–
eq—Equal to.
–
neq—Not equal to.
–
range—Inclusive range of port values. If you enter this operator, enter a
–
second port number value to define the upper limit of the range.
Description
Terminal Access Controller Access Control
System
Talk
Trivial File Transfer Protocol
Time
Who service (rwho)
Connectionless Wireless Session Protocol
Secure Connectionless WSP
Connection-based WSP
Secure Connection-based WSP
X Display Manager Control Protocol
Configuring ACLs
1-13