Map; Enabling Non-Sip Uri Detection In Sip Messages - Cisco 4700M Configuration Manual

Configuring a SIP Parameter Map

Enabling Non-SIP URI Detection in SIP Messages

Associating a SIP Parameter Map with a Layer 3 and Layer 4
Policy Map
Cisco 4700 Series Application Control Engine Appliance Security Configuration Guide
3-122
You can enable detection of non-SIP URIs in SIP messages by using the
uri-non-sip command in parameter map SIP configuration mode.
The syntax of this command is as follows:
uri-non-sip {log} | {mask [log]}
The keywords and options are as follows:
log—Specifies that the ACE log the non-SIP URI.
•
mask—Specifies that the ACE mask the non-SIP URI.
•
For example, to enable the detection of non-SIP URIs in SIP messages and to log
the event, enter:
host1/Admin(config-parammap-sip)# uri-non-sip log
To disable the detection of non-SIP URIs in SIP messages, enter:
host1/Admin(config-parammap-sip)# no uri-non-sip log
You can associate a SIP application protocol inspection parameter map with a
Layer 3 and Layer 4 policy map by using the appl-parameter sip
advanced-options command in policy map class configuration mode.
The syntax of this command is as follows:
appl-parameter sip advanced-options name
The name argument is the name of an existing SIP parameter map. Parameter
maps aggregate SIP traffic-related actions together. Enter the name of an existing
SCCP parameter map as an unquoted text string with no spaces and a maximum
of 64 alphanumeric characters. For details about configuring a SIP parameter
map, see the "Configuring a SIP Parameter Map"
Chapter 3 Configuring Application Protocol Inspection
section.
OL-16202-01